Quick answer
Use the Matphoto Depron 6mm 70x100 plaque for lightweight set props by scoring and snapping for straight cuts, then mounting with a flexible adhesive and mechanical support where needed. Always test your adhesive on a scrap piece first.
Why 6mm Depron works for set props
At 6 mm thick, this Depron plaque offers a balance between rigidity and workability. It holds shape better than thinner foams, making it suitable for flat props, signage, and lightweight structural elements. The 70 x 100 cm size gives you enough material for larger pieces without excessive waste, but it also means you need to plan cuts to maximize yield.
When to choose a different material
Depron is not ideal for load-bearing structures or outdoor use where moisture is present. If your prop needs to support weight or withstand humidity, consider plywood or PVC foam board instead. Also, if you need extreme precision or a smooth, hard surface, Depron may require additional finishing.
Step-by-step: cutting and mounting your Depron plaque
- Plan your cuts: Measure and mark all cuts on the plaque with a pencil, allowing for kerf (blade thickness). Arrange pieces to minimize waste, keeping in mind the 70 x 100 cm size. Common mistake: forgetting to account for blade width, leading to undersized parts. Double-check measurements before cutting.
- Score and snap for straight cuts: Use a sharp utility knife and a metal straightedge to score the Depron several times along the line, then snap it over the edge of a table. For curves, use a fine-tooth saw or hot wire cutter. Checkpoint: always cut on a sacrificial surface to protect your table and avoid tear-out. Keep blades sharp and replace them often for clean edges.
- Prepare surfaces for mounting: Lightly sand the edges and the mounting surface to improve adhesion. Wipe away dust with a damp cloth and let dry. Common mistake: skipping this step, which can cause adhesives to fail. Clean, dust-free surfaces bond better.
- Choose the right adhesive: Use a flexible adhesive such as construction adhesive or foam-safe contact cement. Avoid solvent-based glues that can melt the foam. Test on a scrap piece first. Checkpoint: apply adhesive in a thin, even layer and press firmly. Always test adhesive compatibility on a scrap.
- Add mechanical support if needed: For larger or load-bearing props, reinforce joints with wooden dowels, brackets, or a backing frame. Pre-drill holes to avoid cracking the foam. Common mistake: over-tightening screws, which compresses the foam. Use washers to distribute load when screwing into Depron.
- Finish and protect: Seal the Depron with a foam-safe primer and paint to protect it from moisture and handling. Avoid heavy finishes that may warp the sheet. Checkpoint: apply finishes in thin coats and allow proper drying time. Sealing extends the life of your props.
Product facts
- PLAQUE DEPRON 6MM - 70x 100 CM: 6 mm thick Depron plaque measuring 70 x 100 cm. This thickness provides enough rigidity for flat props while remaining easy to cut with hand tools, and the large sheet size reduces seams on bigger builds.

PLAQUE DEPRON 6MM - 70x 100 CM


